SPEC 45052 CU 600V XLPE Insulation PVC Jacket XHHW-2. CT Rated - Sunlight Resistant - For Direct Burial - Silicone Free

Type TC-ER Control Cable 600 or 1000 Volt Copper Conductors, Cross Linked Polyethylene (XLPE) Insulation XHHW-2 Polyvinyl Chloride (PVC) Jacket, Control Cable Conductor Identification Method 1 Table 2. CT Rated - Sunlight Resistant - For Direct Burial - VW-1 Rated - Silicone Free

Download Category Specifications
PDF Excel Table

Application

Southwire’s 600 or 1000 Volt Type TC-ER control cables are suited for use in wet and dry areas, conduits, ducts, troughs, trays, direct burial, aerial supported by a messenger, and where superior electrical properties are desired. These cables are capable of operating continuously at the conductor temperature not in excess of 90°C for normal operation in wet and dry locations, 130°C for emergency overload, and 250°C for short circuit conditions. The jacket acts as gas/vapor-tight polymeric sheath that is extruded over the core per Sections 501.15(D) and 501.15(E) of the NEC, however when these cables are used in a hazardous location, they may need to be sealed further as described in more detail in the NEC. For uses in Class I, II, and III, Division 2 hazardous locations per NEC Article 501 and 502. Constructions with 3 or more conductors are listed for exposed runs (TC-ER) per NEC 336.10. VW-1 Rated\ - Sunlight Resistant - For Direct Burial - Silicone Free.

Specifications

Select a set of products below for more information:
Conductor Ground Wire
No. of Conductors Size (AWG or kcmil) (mm2) No. of Strands Insulation Thickness (mils) (mm) Size (AWG) No. of Strands Nom. OD (mils) (mm) Nominal Total Weight (lbs/1000') (kgs/km) Allowable Ampacity
952459
2 2
14 AWG 14 AWG
7 7
30 0.76
355 9.03
66 99
952465
3 3
14 AWG 14 AWG
7 7
30 0.76
376 9.56
90 135
952473
4 4
14 AWG 14 AWG
7 7
30 0.76
409 10.41
110 164
952481
5 5
14 AWG 14 AWG
7 7
30 0.76
447 11.36
130 193
952499
6 6
14 AWG 14 AWG
7 7
30 0.76
486 12.35
152 226
952440
7 7
14 AWG 14 AWG
7 7
30 0.76
482 12.25
169 251
952507
8 8
14 AWG 14 AWG
7 7
30 0.76
559 14.20
208 310
952572
9 9
14 AWG 14 AWG
7 7
30 0.76
598 15.19
231 344
952598
12 12
14 AWG 14 AWG
7 7
30 0.76
670 17.02
295 439
952606
15 15
14 AWG 14 AWG
7 7
30 0.76
742 18.85
359 534
952614
19 19
14 AWG 14 AWG
7 7
30 0.76
780 19.81
439 654
952630
25 25
14 AWG 14 AWG
7 7
30 0.76
952 24.20
603 897
952648
30 30
14 AWG 14 AWG
7 7
30 0.76
1006 25.56
707 1053
952655
37 37
14 AWG 14 AWG
7 7
30 0.76
1083 27.52
849 1264
953042
2 2
12 AWG 12 AWG
7 7
30 0.76
388 9.87
88 132
953059
3 3
12 AWG 12 AWG
7 7
30 0.76
408 10.36
118 175
953067
4 4
12 AWG 12 AWG
7 7
30 0.76
449 11.41
153 227
953075
5 5
12 AWG 12 AWG
7 7
30 0.76
487 12.38
175 260
953091
7 7
12 AWG 12 AWG
7 7
30 0.76
561 14.26
248 370
953117
9 9
12 AWG 12 AWG
7 7
30 0.76
657 16.70
316 470
953125
10 10
12 AWG 12 AWG
7 7
30 0.76
714 18.16
349 520
953133
12 12
12 AWG 12 AWG
7 7
30 0.76
738 18.76
405 603
953141
15 15
12 AWG 12 AWG
7 7
30 0.76
819 20.81
496 739
953158
19 19
12 AWG 12 AWG
7 7
30 0.76
904 22.96
648 964
953174
25 25
12 AWG 12 AWG
7 7
30 0.76
1051 26.70
836 1244
953190
37 37
12 AWG 12 AWG
7 7
30 0.76
1198 30.44
1181 1758
952861
2 2
10 AWG 10 AWG
7 7
30 0.76
448 11.38
122 181
952879
3 3
10 AWG 10 AWG
7 7
30 0.76
459 11.67
163 243
952895
4 4
10 AWG 10 AWG
7 7
30 0.76
547 13.90
230 342
952887
5 5
10 AWG 10 AWG
7 7
30 0.76
603 15.34
273 406
952911
7 7
10 AWG 10 AWG
7 7
30 0.76
639 16.23
355 528
952929
8 8
10 AWG 10 AWG
7 7
30 0.76
711 18.08
408 607
952937
9 9
10 AWG 10 AWG
7 7
30 0.76
743 18.88
447 665
952952
12 12
10 AWG 10 AWG
7 7
30 0.76
879 22.34
614 913
952960
15 15
10 AWG 10 AWG
7 7
30 0.76
973 24.72
748 1114
952978
19 19
10 AWG 10 AWG
7 7
30 0.76
1045 26.54
932 1388

Standards & References

  • ASTM B3: Soft or Annealed Copper Wire
  • ASTM B8: Concentric-Lay-Stranded Copper Conductors
  • UL 44: Thermoset-Insulated Wires and Cables
  • UL 44: VW-1 Vertical flame test on individual conductors
  • UL 1277: Electrical Power and Control Tray Cables
  • UL 1685: FT4 Vertical-Tray Fire Propagation and Smoke Release Test
  • ICEA S-58-679: Control Cable Conductor Identification Method 1 Table 2
  • ICEA S-73-532: Standard for Control, Thermocouple Extension and Instrumentation Cables
  • ICEA S-95-658: (NEMA WC70) Power Cables Rated 2000 Volts or Less for the Distribution of Electrical Energy
  • IEEE 1202: FT4 Flame Test (70,000) BTU/hr Vertical Tray Test

Construction

  • Conductor: 7 strands class B compressed bare copper per ASTM B3 and ASTM B8
  • Insulation: Cross Linked Polyethylene (XLPE) XHHW-2, 30 Mils thick for all cable sizes. VW-1 Rated
  • Filler: Polypropylene filler on cables with 5 or less conductors
  • Binder: Polyester flat thread binder tape applied for cables with more than 5 conductors
  • Overall Jacket: Polyvinyl Chloride (PVC) Jacket

Resources

There are no downloadable resources for this product.