SPEC 45005 ROYAL GUARD™ CU 600V EPR Insulation Thermoset CPE-TS Jacket RHH/RHW-2. CT Rated 1/0 and Larger - Sunlight Resistant - Silicone Free

Power Cable 600Volt Single Conductor Copper, Lead Free Ethylene Propylene Rubber (EPR) insulation RHH/RHW-2 USE-2 Cross-Linked/Thermoset Chlorinated Polyethylene (CPE-TS) Jacket. CT Rated 1/0 and Larger - For Direct Burial - Sunlight Resistant - Oil Resistant - Silicone Free

Download Category Specifications
Excel Table

Application

Southwire’s 600 Volt power cables are suited for use in wet and dry areas, conduits, ducts, troughs, trays, direct burial, aerial supported by a messenger, and where superior electrical properties are desired. These cables are capable of operating continuously at the conductor temperature not in excess of 90°C for normal operation in wet and dry locations, 130°C for emergency overload, and 250°C for short circuit conditions. For uses in Class I, II, and III, Division 2 hazardous locations per NEC Article 501 and 502. CT Rated 1/0 and Larger - Sunlight Resistant - Oil Resistant - Silicone Free.

Specifications

Select a set of products below for more information:
Conductor Ground Wire
No. of Conductors Size (AWG or kcmil) (mm2) No. of Strands Insulation Thickness (mils) (mm) Size (AWG) No. of Strands Nom. OD (mils) (mm) Nominal Total Weight (lbs/1000') (kgs/km) Allowable Ampacity
592004
1 1
8 AWG 8 AWG
7 7
15 0.38
278 7.06
77 115
589493
1 1
6 AWG 6 AWG
7 7
30 0.76
342 8.69
122 181
589492
1 1
4 AWG 4 AWG
7 7
30 0.76
390 9.91
177 263
589491
1 1
2 AWG 2 AWG
7 7
30 0.76
455 11.56
263 391
589490
1 1
1 AWG 1 AWG
19 19
45 1.14
536 13.61
346 515
589495
1 1
1/0 AWG 1/0 AWG
19 19
45 1.14
576 14.63
422 628
589496
1 1
2/0 AWG 2/0 AWG
19 19
45 1.14
622 15.80
516 768
592011
1 1
3/0 AWG 3/0 AWG
19 19
45 1.14
663 16.84
632 940
589500
1 1
4/0 AWG 4/0 AWG
19 19
45 1.14
728 18.49
781 1162
589497
1 1
250 KCMIL 250 KCMIL
37 37
65 1.65
836 21.23
956 1422
589499
1 1
350 KCMIL 350 KCMIL
37 37
65 1.65
939 23.85
1292 1922
589501
1 1
500 KCMIL 500 KCMIL
37 37
65 1.65
1062 26.97
1787 2659
595421
1 1
600 KCMIL 600 KCMIL
61 61
65 1.65
1203 30.56
2159 3213
592017
1 1
750 KCMIL 750 KCMIL
61 61
65 1.65
1278 32.46
2644 3935
589488
1 1
1000 KCMIL 1000 KCMIL
91 91
65 1.65
1443 36.65
3464 5156

Standards & References

  • ASTM B3: Soft or Annealed Copper Wire
  • ASTM B8: Concentric-Lay-Stranded Copper Conductors
  • ASTM B33: Standard Specification for Tin-Coated Soft or Annealed Copper Wire
  • UL 44: Thermoset-Insulated Wires and Cables
  • UL 854: Service Entrance Cable
  • UL 1685: FT4 Vertical-Tray Fire Propagation and Smoke Release Test
  • ICEA S-95-658: (NEMA WC70) Power Cables Rated 2000 Volts or Less for the Distribution of Electrical Energy
  • CT USE: Sizes 1/0 AWG and Larger
  • IEEE 1202: FT4 Flame Test (70,000) BTU/hr Vertical Tray Test
  • VW-1: (Vertical-Wire) Flame Test

Construction

  • Conductor: Class B compressed stranded tinned copper per ASTM B33 and ASTM B8
  • Binder Tape: Mylar Tape
  • Insulation: Lead Free Ethylene Propylene Rubber (EPR) Type RHH/RHW-2 USE-2
  • Overall Jacket: Lead Free & Silicone-Free Cross-Linked/Thermoset Chlorinated Polyethylene (CPE-TS) Jacket

Resources

There are no downloadable resources for this product.