15KV Copper XLP MV LLDPE Jacket

Copper Conductor. TRXLP Insulation. Bare Copper Concentric Neutrals. Low Density Polyethylene Jacket.

Download Category Specifications
Excel Table

Application

Predominantly used for primary underground distribution in conduit systems suitable for use in wet or dry locations, direct burial, underground duct, and where exposed to sunlight. To be used at 15,000 volts or less and at conductor temperatures not to exceed 90°C for normal operation.

Specifications

Select a set of products below for more information:
Conductor Ground Wire
No. of Conductors Size (AWG or kcmil) (mm2) No. of Strands Insulation Thickness (mils) (mm) Size (AWG) No. of Strands Nom. OD (mils) (mm) Nominal Total Weight (lbs/1000') (kgs/km) Allowable Ampacity
628194
1 1
500 KCMIL 500 KCMIL
37 37
175 4.45
1592 40.46
2725 4055
277590
1 1
2 AWG 2 AWG
7 7
220 5.59
1071 27.21
750 1116
621985
1 1
1 AWG 1 AWG
19 19
175 4.45
1020 25.91
811 1207
267161
1 1
1/0 AWG 1/0 AWG
19 19
220 5.59
1150 29.22
1018 1514
616362
1 1
2/0 AWG 2/0 AWG
19 19
175 4.45
1137 28.90
1168 1737
628165
1 1
4/0 AWG 4/0 AWG
19 19
220 5.59
1300 33.03
1351 2010
628167
1 1
350 KCMIL 350 KCMIL
37 37
220 5.59
1512 38.42
2057 3062
612883
1 1
500 KCMIL 500 KCMIL
37 37
220 5.59
1736 44.11
2878 4283
607427
1 1
750 KCMIL 750 KCMIL
58 58
175 4.45
1775 45.11
3858 5742
663120
3 3
750 KCMIL 750 KCMIL
58 58
175 4.45
3430 87.12
10440 15536
620367
1 1
1000 KCMIL 1000 KCMIL
61 61
175 4.45
1942 49.34
4491 6683

Standards & References

Southwire 15kV HI-DRI Primary UD TRXLP Cable meets or exceeds the following ASTM specifications:

  • B3: Soft Annealed Copper Wire
  • B8: Concentric-Lay-Stranded Copper Conductors, Hard, Medium-Hard or Soft
  • ICEA S-94-649
  • AEIC CS-8
  • RUS U-1

Construction

The cable is composed of a moisture blocked reverse lay, compressed stranded soft drawn copper, covered by a semi-conducting cross-linked polyethylene strand shield, a tree-retardant cross-linked polyethylene primary insulation, and a semi-conducting cross-linked polyethylene insulation shield. Conductors are available with 100% insulation level. A concentric neutral of bare copper wires and a sunlight resistant, -40°C rated, insulating linear low density polyethylene jacket are applied over the insulation shield. The cable is identified by surface print on the jacket and with the lightning bolt symbol for supply cables indented in the jacket. Has red extruded stripes.