SPEC: 45413

CU 600V XLPE Insulation. RHH/RHW-2 PV SPEC45413

Single Conductor Photovoltaic (Type PV) Power Cable 600 Volt Copper Conductor XLPE Insulation. Sizes 14 AWG through 1000 kcmil. Heat, Moisture, Sunlight Resistant RoHS. 90°C

Download Category Specifications

Application & Features

Southwire’s 600 Volt power cables are suited for use in wet and dry areas, conduits, ducts, troughs, trays, direct burial, aerial supported by a messenger, and where superior electrical properties are desired. These cables are capable of operating continuously at the conductor temperature not in excess of 90°C for normal operation in wet and dry locations, 130°C for emergency overload, and 250°C for short circuit conditions.

Specifications

Select a set of products below for more information:

	Cond. Size	Conductor Number	Cond. Strands	Diameter Over Conductor (in) (cm)	Insulation Thickness (mils) (mm)	Approx. OD (in) (cm)	Copper Weight (lbs/1000') (kgs/km)	Approx. Weight (lbs/1000') (kgs/km)
More Options	12 AWG 12 AWG	1 1	19 19	0.090 0.23	60 1.52	0.213 0.54	20 30	36 54
More Options	10 AWG 10 AWG	1 1	19 19	0.117 0.30	60 1.52	0.231 0.59	32 48	47 70

TBA stock codes are estimations only and actual product may vary. Please wait until a stock code is assigned to purchase connectors and/or fittings.

	Cond. Size	Conductor Number	Min. Bend Radius (in) (cm)	DC Resistance at 25C (ohms/1000') (ohms/km)	AC Resistance at 75C (ohms/1000') (ohms/km)	Inductive Reactance (ohms/1000') (ohms/km)	Allowable Ampacity Raceway 75C	Allowable Ampacity Raceway 90C
More Options	12 AWG 12 AWG	1 1	0.9 2.29	1.662 2.47	2.002 2.98	0.054 0.08	25 25	30 30
More Options	10 AWG 10 AWG	1 1	0.9 2.29	1.040 1.55	1.253 1.86	0.050 0.07	35 35	40 40

Size	Black	White	Red	Green	Green/Yellow
AWG/kcmil AWG/kcmil
12 12	567946
10 10	567947	567949	567948

Standards & References

ASTM B3 Soft or Annealed Copper Wire
ASTM B8 Concentric-Lay-Stranded Copper Conductors
ASTM B787 19 Wire Combination Unilay-Stranded Copper Conductors
UL 44 Thermoset-Insulated Wires and Cables
UL 4703 Standard for Photovoltaic Wire
Made in America: Compliant with both Buy American and Buy America Act (BAA) requirements per 49 U.S.C. § 5323(j) and the Federal Transit Administration Buy America requirements per 49 C.F.R. part 661
VW-1 Vertical-Wire Flame Test (Optional)

Construction

Conductor:Stranded bare copper per ASTM B3 and ASTM B8 or B787
Insulation:Cross Linked Polyethylene (XLPE). Alternative colors available upon request (see Table 3 below)

Resources

There are no downloadable resources for this product.