2/0-19 CU 3/C XLP 2x3GW 1x8GC MP-GC RHINOPOWER 15KV 100% BLACK PVC JKT SPEC47818 57024699

Southwire #: 57024699

Download Category Specifications

PDF Excel Table

Select Product Specifications

Construction

Outer Jacket / Armor Color

BLACK

Packaging

Application & Features

RHINOPOWER^TM Type MP-GC mine power feeder cable is a heavy-duty power cable for use in stationary horizontal HV mine power distribution circuits, for permanent or semi-portable applications with power transmission in deep mines, surface mines, open pits, tunnels, in conduit or duct (not to exceed max rated voltage), and suitable for direct burial in wet or dry locations. For vertical drop requirements consult with factory application specialist.

Specifications

Cond. Size	2/0 AWG 2/0 AWG
Conductor Number	3 3
Cond. Strands	19 19
Diameter Over Conductor (in) (cm)	0.376 0.96	inch cm
Insulation Thickness (mils) (mm)	175 4.45	mils mm
Diameter Over Insulation (in) (cm)	0.756 1.92	inch cm
Ground Check Size	8 8
Jacket Thickness (mils) (mm)	140 3.56	mils mm
Approx. OD (in) (cm)	2.150 5.46	inch cm
Approx. Weight (lbs/1000') (kgs/km)	3090 4598	lbs/1000' kgs/km

* Strand count meets minimum number per ASTM
TBA stock codes are estimations only and actual product may vary. Please wait until a stock code is assigned to purchase connectors and/or fittings.

Standards & References

ASTM B3 Soft or Annealed Copper Wire
ASTM B8 Concentric-Lay-Stranded Copper Conductors
ASTM B496 Compact Round Concentric-lay-standard copper
ICEA S-75-381 Portable and Power Feeder Cables for Use in Mines
MSHA Approved

Construction

Conductor:Class B compact stranded bare copper per ASTM B3 and B496
Conductor Shield:Semi-conducting cross-linked copolymer
Insulation:100% Insulation Level Ethylene Propylene Rubber (EPR)
Insulation Shield:Strippable semi-conducting cross-linked copolymer
Copper Tape Shield:Helically wrapped 5 mil copper tape with 25% overlap
Grounding Conductors:Two class B compressed stranded bare copper per ASTM B3 and B8
Ground Check:Class B compressed stranded bare copper per ASTM B3 and B8 with yellow high strength, polypropylene insulation
Filler:Rubber fillers as needed
Reinforcement:Tape and reinforcing twine applied over the core for improved mechanical integrity and ease of stripping
Jacket:Black, single layer, Polyvinyl Chloride (PVC). Alternate jacket colors available
Reflective Stripe: (optional) Highly visible reflective stripe embedded into the outer jacket to increase safety and help prevent cable runover (contact your sales representative for part number)

Resources

There are no downloadable resources for this product.