Cable Pulling & Fishing

PULLER, CABLE M3K-M MAXIS 3K W/ MOTOR 1 EA p-57648401 57648401

Southwire #: 57648401 Model #: M3K-M

Write a Review

A 3,000 lb. cable puller that only requires one person to set up in less than 2 minutes. The Maxis® 3K cable puller features two pulling speeds:25 fpm at low and 100 FEP on high. The M3K-M is able to quickly adapt from underground to overhead pulls.

Where to Buy

Download Category Specifications

PDF Excel Table

PULLER, CABLE M3K-M MAXIS 3K W/ MOTOR 1 EA

Features & Benefits

Fast setup and operation: one person, 2 minute setup and operate.
High speed: 25 fpm on low (at no load) and 100 fpm on high (at no load).
Lightweight: Weights 51 lb. No need to bolt to the ground.
No need to bolt to the ground on most pulls.
High Capacity: 3,000 lb. pulling force.

Specifications

Model #	M3K-M M3K-M
UPC #	032886884184 032886884184
Product Height	15.0 38.10	inch cm
Product Width	20.0 50.80	inch cm
Depth	50.0 127.00	inch cm
Rated Capacity	3,000-6,000 LBS 3,000-6,000 LBS

Resources

M3K Exploded Diagram

M3K Owner's Manual

I need to find replacement parts for our Maxis 3000. I looked at the manual for it and i need pieces 1 through 8. Are these available for purchase in Canada?

Asked by: Daryl

Yes, these parts are available in Canada. P3-207 Adjustable Leg P3-208-55A-H Conduit Adaptors (1" - 4") P3-122 Clevis Pin (2 3/8") P3-208-51 Front Extension P3-122 Clevis Pin (3/8" x 1-3/4")

Answered by: Southwire

Date published: 2019-10-02

Where do I get replacement parks for this m3k tugger

Asked by: Jeff1982

Please call our team at 855-798-6657 for assistance and they will be happy to help!

Answered by: Southwire

Date published: 2019-10-02

How do you pull 8ft of cable out of conduit that is coming up into the bottom of a panel . The bottom of the panel is 2ft from the the ground and you there a wall 5 ft in front of the panel?

Asked by: Sparky77

The best solution is to make half hitches in the rope.

Answered by: Southwire

Date published: 2019-08-14

will it pull 4- 3350kcmil in to a 4 inch pvc

Asked by: elite

We recommend that you use the SIMpull® Cable Pull Calculator (https://www.southwire.com/support/SIMpullCablePullCalculator.htm) to verify which puller to use.

Answered by: Southwire

Date published: 2019-02-27

How much space is needed for a side entrance pull into a panel

Asked by: Wsteve

Please call 855-SWTOOLS (855-798-6657) to discuss specifics of this pull.

Answered by: Southwire

Date published: 2019-01-21

Will this pull 3 500mcm THHN in 4” conduit 100’

Asked by: asteb98

Depending on the conduit run, the Maxis M3K-M should work. For any further questions please contact our team at 855-798-6657.

Answered by: Southwire

Date published: 2019-01-21

Do you have a graph that correlates pulling speed with pulling force? 100 fmp at no load should decrease to something else at 500 lbs, 1000 lbs, 2000 lbs, etc.

Asked by: Robin Hood

We are happy to help, please call our Tools Team at 855-798-6657 for further assistance!

Answered by: Southwire

Date published: 2018-11-15

We are doing a cable pull and are uncertain if the 3K is beefy enough, Any idea on where I could find the information on how to size my cable puller correctly?

Asked by: jwright

We are happy to help, please call our Tools Team at 855-798-6657 for further assistance!

Answered by: Southwire

Date published: 2019-11-17

Would like to know the price and garantie for this puller

Asked by: Mathieu

Please see the link below to our Where to Buy page or call 855-798-6657 and a member of our team can help you find pricing! http://www.southwiretools.com/tools/basic/wheretobuy

Answered by: swtools

Date published: 2018-08-27

Is this puller compatible with Milwaukee original Hole Hawg or either the new 18 volt battery Hole Hawg or 18 volt battery Super Hawg?

Asked by: MAF44

The Milwaukee battery powered Hole Hawg and Super Hawg drills are not compatible with the Maxis M3K cable puller due to the change in the drill’s trigger housing. Thanks for using Southwire Tools.

Answered by: swtools

Date published: 2018-03-13

How and where do I get replacement capstans/spindles for my super hawg 3000? Is there a part number to look up? Platt Electric couldn't find anything.

Asked by: Dave Holmes

Please call our Tools Team at 855-798-6657 for assistance having capstans and spindles replaced.

Answered by: swtools

Date published: 2018-03-07

Is there a way to get extensions for this pulling machine to reach higher? 

Asked by: Jamesmagg

Southwire’s M3K Cable Puller can be extended using a stick of 3” rigid steel conduit (not to exceed 10’). For more information concerning specific applications, please contact customer service at 1-855-798-6657. Thank you for using Southwire Equipment.

Answered by: SouthwireTools

Date published: 2018-03-06

Is there an instruction guide available for this unit online or in print?

Asked by: DonK

The owner’s manual for the Maxis 3K Cable Puller can be found at the following link http://www.southwiretools.com/tools/tools/M3K-M under the Downloads tab. Also, please check out the video in this link https://www.youtube.com/watch?v=qybExb2sMFY. Thank you.

Answered by: SouthwireTools

Date published: 2019-02-22

What is the warranty period for the 3K Cable Puller Gear Box?

Asked by: BKC1

This product has a 1 year limited warranty. Please contact our customer service team at 1-855-798-6657 and our team will assist you. Thank you.

Answered by: SouthwireTools

Date published: 2017-06-27

Where may I buy it?

Asked by: matos

Please see the "Where to Buy" section of our website to find a distributor near you: http://www.southwiretools.com/tools/basic/wheretobuy

Answered by: SouthwireTools

Date published: 2017-06-05

Hi, can you tell me if the gearbox is a closed unit ? when replacing oil in the gearbox what type should I use ?

Asked by: MikeC

The Maxis® 3K has a sealed gearbox, this design allows for longer service intervals. We recommend the use of 220W fully synthetic worm gear oil in all of our gearboxes.

Answered by: SouthwireTools

Date published: 2017-02-06

Hi there. Can i purchase parts for the Maxis 3K ? IF SO, FROM WHERE

Asked by: EMAXFELDT

Please contact our customer service team at 1-855-798-6657 and they will assist you with this issue. Thank you.

Answered by: SouthwireTools

Date published: 2017-01-24

are there any photos of the 3k puller attached to a 2" trailer receiver? Are any additional attachments required?

Asked by: souza

There are no additional attachments required to attach a Maxis 3K to a standard 2” receiver. Please contact our customer service team at ToolCSN@Southwire.com and they will assist you with this request. Thank you.

Answered by: SouthwireTools

Date published: 2017-06-18

Price?Canadian

Asked by: Warren

Please call our customer service team at 1-855-798-6657 and they will find a distributor and pricing in your area.

Answered by: SouthwireTools

Date published: 2017-06-18

Where can I get replacement parts?for maxis3000

Asked by: Andy

Please call our customer service team at 1-855-798-6657 for replacement parts.

Answered by: SouthwireTools

Date published: 2017-06-18

Where do I buy the shafts / bolt foe the wheel that the rope goes around. The shafts that goes into the gear box. Mine broke right off while in use.

Asked by: Besr

Please call our customer service team at 1-855-798-6657 and they will assist you with this.

Answered by: SouthwireTools

Date published: 2019-05-27

PULLER, CABLE M3K-M MAXIS 3K W/ MOTOR 1 EA p-57648401 57648401

A 3,000 lb. cable puller that only requires one person to set up in less than 2 minutes. The Maxis® 3K cable puller features two pulling speeds:25 fpm at low and 100 FEP on high. The M3K-M is able to quickly adapt from underground to overhead pulls.

Features & Benefits

Specifications

Resources

I need to find replacement parts for our Maxis 3000. I looked at the manual for it and i need pieces 1 through 8. Are these available for purchase in Canada?

Where do I get replacement parks for this m3k tugger

How do you pull 8ft of cable out of conduit that is coming up into the bottom of a panel . The bottom of the panel is 2ft from the the ground and you there a wall 5 ft in front of the panel?

will it pull 4- 3350kcmil in to a 4 inch pvc

How much space is needed for a side entrance pull into a panel

Will this pull 3 500mcm THHN in 4&rdquo; conduit 100&rsquo;

Do you have a graph that correlates pulling speed with pulling force? 100 fmp at no load should decrease to something else at 500 lbs, 1000 lbs, 2000 lbs, etc.

We are doing a cable pull and are uncertain if the 3K is beefy enough, Any idea on where I could find the information on how to size my cable puller correctly?

Would like to know the price and garantie for this puller

Is this puller compatible with Milwaukee original Hole Hawg or either the new 18 volt battery Hole Hawg or 18 volt battery Super Hawg?

How and where do I get replacement capstans/spindles for my super hawg 3000? Is there a part number to look up? Platt Electric couldn't find anything.

Is there a way to get extensions for this pulling machine to reach higher?&nbsp;

Is there an instruction guide available for this unit online or in print?

What is the warranty period for the 3K Cable Puller Gear Box?

Where may I buy it?

Hi, can you tell me if the gearbox is a closed unit ? when replacing oil in the gearbox what type should I use ?

Hi there. Can i purchase parts for the Maxis 3K ? IF SO, FROM WHERE

are there any photos of the 3k puller attached to a 2&quot; trailer receiver? Are any additional attachments required?

Price?Canadian

Where can I get replacement parts?for maxis3000

Where do I buy the shafts / bolt foe the wheel that the rope goes around. The shafts that goes into the gear box. Mine broke right off while in use.

Will this pull 3 500mcm THHN in 4” conduit 100’

Is there a way to get extensions for this pulling machine to reach higher?

are there any photos of the 3k puller attached to a 2" trailer receiver? Are any additional attachments required?