SPEC 45258 CU 600/1000V XLPE Insulation PVC Jacket XHHW-2. CT Rated - Sunlight Resistant - For Direct Burial - Silicone Free

Type TC-ER Power Cable 600 or 1000 Volt Four Conductor Copper, Cross Linked Polyethylene (XLPE) insulation XHHW-2 Polyvinyl Chloride (PVC) Jacket with 1 Bare CU Ground. Silicone Free. CT Rated - Sunlight Resistant - For Direct Burial - Silicone Free

Download Category Specifications
Excel Table

Application

Southwire’s 600 or 1000 Volt Type TC-ER power cables are suited for use in wet and dry areas, conduits, ducts, troughs, trays, direct burial, aerial supported by a messenger, and where superior electrical properties are desired. These cables are capable of operating continuously at the conductor temperature not in excess of 90°C for normal operation in wet and dry locations, 130°C for emergency overload, and 250°C for short circuit conditions. For uses in Class I, II, and III, Division 2 hazardous locations per NEC Article 501 and 502. Constructions with 3 or more conductors are listed for exposed runs (TC-ER) per NEC 336.10. Sunlight Resistant - For Direct Burial - Silicone Free

Specifications

Select a set of products below for more information:
Conductor Ground Wire
No. of Conductors Size (AWG or kcmil) (mm2) No. of Strands Insulation Thickness (mils) (mm) Size (AWG) No. of Strands Nom. OD (mils) (mm) Nominal Total Weight (lbs/1000') (kgs/km) Allowable Ampacity
557009
4 4
8 AWG 8 AWG
7 7
45 1.14
10 10
755 19.18
404 601
560102
4 4
6 AWG 6 AWG
7 7
45 1.14
8 8
902 22.92
613 913
556993
4 4
4 AWG 4 AWG
7 7
45 1.14
8 8
918 23.34
805 1198
554303
4 4
2 AWG 2 AWG
7 7
45 1.14
6 6
1046 26.59
1186 1764
602011
4 4
1 AWG 1 AWG
19 19
55 1.40
6 6
1214 30.86
1505 2240
554436
4 4
1/0 AWG 1/0 AWG
19 19
55 1.40
6 6
1299 33.00
1755 2611
556985
4 4
2/0 AWG 2/0 AWG
19 19
55 1.40
6 6
1429 36.32
2156 3209
602037
4 4
3/0 AWG 3/0 AWG
19 19
55 1.40
4 4
1521 38.65
2694 4009
554444
4 4
4/0 AWG 4/0 AWG
19 19
55 1.40
4 4
1721 43.73
3425 5098
602052
4 4
250 KCMIL 250 KCMIL
37 37
65 1.65
4 4
1842 46.79
4004 5958
602078
4 4
350 KCMIL 350 KCMIL
37 37
65 1.65
3 3
2095 53.23
5351 7964
554469
4 4
500 KCMIL 500 KCMIL
37 37
65 1.65
2 2
2382 60.53
7427 11053
649649
4 4
600 KCMIL 600 KCMIL
61 61
80 2.03
4/0 4/0
2867 72.84
9634 14337
570961
4 4
750 KCMIL 750 KCMIL
61 61
80 2.03
1 1
3032 77.01
11355 16898

Standards & References

  • ASTM B3: Soft or Annealed Copper Wire
  • ASTM B8: Concentric-Lay-Stranded Copper Conductors
  • UL 44: Thermoset-Insulated Wires and Cables
  • UL 1277: Electrical Power and Control Tray Cables
  • UL 1685: Vertical-Tray Fire Propagation and Smoke Release Test
  • ICEA S-58-679: Control Cable Conductor Identification Method 3 (1-BLACK, 2-RED, 3-BLUE)
  • ICEA S-95-658: (NEMA WC70) Power Cables Rated 2000 Volts or Less for the Distribution of Electrical Energy
  • IEEE 1202: FT4 Flame Test (70,000) BTU/hr Vertical Tray Test

Construction

  • Conductor: Class B compressed stranded bare copper per ASTM B3 and ASTM B8
  • Insulation: Cross Linked Polyethylene (XLPE) Type XHHW-2
  • Grounding Conductor: Class B compressed stranded bare copper per ASTM B3 and ASTM B8 (cable size 8 & 6 has insulated green ground)
  • Filler: Paper filler (cable size 8 & 6 uses Polypropylene filler)
  • Binder: Polyester flat thread binder tape for cable sizes larger than 2 AWG
  • Overall Jacket: Polyvinyl Chloride (PVC) Jacket

Resources

There are no downloadable resources for this product.