SPEC 45055 TCU 600V EPR Insulation Thermoplastic CPE-TP Jacket XHHW-2. CT Rated - Sunlight Resistant - For Direct Burial - Silicone Free

Type TC-ER Control Cable 600 Volt Tinned Copper Conductors, Ethylene Propylene Rubber (EPR) Insulation XHHW-2 Thermoplastic Chlorinated Polyethylene (CPE-TP) Jacket, Control Cable Conductor Identification Method 1 Table 2. VW-1 Rated #14 - #10 AWG. CT Rated - Sunlight Resistant - For Direct Burial - Silicone Free

Download Category Specifications
Excel Table

Application

Southwire’s 600 Volt Type TC-ER control cables are suited for use in wet and dry areas, conduits, ducts, troughs, trays, direct burial, aerial supported by a messenger, and where superior electrical properties are desired. These cables are capable of operating continuously at the conductor temperature not in excess of 90°C for normal operation in wet and dry locations, 130°C for emergency overload, and 250°C for short circuit conditions. For uses in Class I, II, and III, Division 2 hazardous locations per NEC Article 501 and 502. Constructions with 3 or more conductors are listed for exposed runs (TC-ER) per NEC 336.10. VW-1 Rated #14 - #10 AWG. Sunlight Resistant - For Direct Burial - Silicone Free

Specifications

Select a set of products below for more information:
Conductor Ground Wire
No. of Conductors Size (AWG or kcmil) (mm2) No. of Strands Insulation Thickness (mils) (mm) Size (AWG) No. of Strands Nom. OD (mils) (mm) Nominal Total Weight (lbs/1000') (kgs/km) Allowable Ampacity
591931
2 2
16 AWG 16 AWG
7 7
332 8.43
52 77
591932
3 3
16 AWG 16 AWG
7 7
30 0.76
351 8.92
67 99
591933
4 4
16 AWG 16 AWG
7 7
30 0.76
382 9.70
83 123
591934
5 5
16 AWG 16 AWG
7 7
30 0.76
415 10.55
100 149
591935
7 7
16 AWG 16 AWG
7 7
30 0.76
451 11.46
129 192
591936
9 9
16 AWG 16 AWG
7 7
30 0.76
555 14.10
178 266
591937
12 12
16 AWG 16 AWG
7 7
30 0.76
618 15.70
225 336
591944
2 2
14 AWG 14 AWG
7 7
30 0.76
366 9.30
66 98
591947
3 3
14 AWG 14 AWG
7 7
30 0.76
388 9.86
86 128
591948
4 4
14 AWG 14 AWG
7 7
30 0.76
423 10.74
108 161
591949
5 5
14 AWG 14 AWG
7 7
30 0.76
461 11.71
130 193
591950
7 7
14 AWG 14 AWG
7 7
30 0.76
502 12.75
171 254
591951
9 9
14 AWG 14 AWG
7 7
30 0.76
616 15.65
233 346
591952
12 12
14 AWG 14 AWG
7 7
30 0.76
692 17.58
299 446
591953
15 15
14 AWG 14 AWG
7 7
30 0.76
560 14.22
413 615
591954
19 19
14 AWG 14 AWG
7 7
30 0.76
560 14.22
413 615
591959
2 2
12 AWG 12 AWG
7 7
30 0.76
404 10.26
87 129
591960
3 3
12 AWG 12 AWG
7 7
30 0.76
466 11.84
117 174
591962
4 4
12 AWG 12 AWG
7 7
30 0.76
469 11.91
147 219
591963
5 5
12 AWG 12 AWG
7 7
30 0.76
543 13.79
198 295
591964
7 7
12 AWG 12 AWG
7 7
30 0.76
589 14.96
254 378
591965
9 9
12 AWG 12 AWG
7 7
30 0.76
589 14.96
307 457
591966
12 12
12 AWG 12 AWG
7 7
30 0.76
466 11.84
412 613
591968
19 19
12 AWG 12 AWG
7 7
30 0.76
934 23.72
660 982
591973
2 2
10 AWG 10 AWG
7 7
30 0.76
448 11.38
117 174
591974
3 3
10 AWG 10 AWG
7 7
30 0.76
476 12.09
161 239
591976
4 4
10 AWG 10 AWG
7 7
30 0.76
560 14.22
225 335
591977
5 5
10 AWG 10 AWG
7 7
30 0.76
602 15.29
268 398
591978
7 7
10 AWG 10 AWG
7 7
30 0.76
655 16.64
356 529
591979
9 9
10 AWG 10 AWG
7 7
30 0.76
765 19.43
451 671
591980
12 12
10 AWG 10 AWG
7 7
30 0.76
899 22.83
619 922
591938
15 15
16 AWG 16 AWG
7 7
30 0.76
684 17.39
273 407

Standards & References

  • ASTM B8: Concentric-Lay-Stranded Copper Conductors
  • ASTM B33: Standard Specification for Tin-Coated Soft or Annealed Copper Wire
  • UL 44: Thermoset-Insulated Wires and Cables
  • UL 44: VW-1 Vertical flame test on individual conductors
  • UL 1277: Electrical Power and Control Tray Cables
  • UL 1685: FT4 Vertical-Tray Fire Propagation and Smoke Release Test
  • ICEA S-58-679: Control Cable Conductor Identification Method 1 Table 2
  • ICEA S-73-532: Standard for Control, Thermocouple Extension and Instrumentation Cables
  • ICEA S-95-658: (NEMA WC70) Power Cables Rated 2000 Volts or Less for the Distribution of Electrical Energy
  • IEEE 1202: FT4 Flame Test (70,000) BTU/hr Vertical Tray Test

Construction

  • Conductor: 7 strands class B compressed tinned copper per ASTM B33 and ASTM B8
  • Insulation: Ethylene Propylene Rubber (EPR) XHHW-2, 30 Mils thick for all cable sizes. VW-1 Rated #14 - #10 AWG
  • Filler: Polypropylene filler on cables with 5 or less conductors
  • Binder: Polyester flat thread binder tape applied for cables with more than 5 conductors
  • Overall Jacket: Thermoplastic Chlorinated Polyethylene (CPE-TP) Jacket

Resources

There are no downloadable resources for this product.