SPEC 45003 CU 600V XLPE Insulation RHH/RHW-2. CT Rated 1/0 and Larger - Sunlight Resistant - Silicone Free

Power Cable 600Volt Single Conductor Copper, Cross Linked Polyethylene (XLPE) insulation RHH/RHW-2/USE-2. CT Rated 1/0 and Larger - Sunlight Resistant - Silicone Free

Download Category Specifications
Excel Table

Application

Southwire’s 600 Volt power cables are suited for use in wet and dry areas, conduits, ducts, troughs, trays, direct burial, aerial supported by a messenger, and where superior electrical properties are desired. These cables are capable of operating continuously at the conductor temperature not in excess of 90°C for normal operation in wet and dry locations, 130°C for emergency overload, and 250°C for short circuit conditions. For uses in Class I, II, and III, Division 2 hazardous locations per NEC Article 501 and 502. CT Rated 1/0 and Larger - Sunlight Resistant - Silicone Free. Rated for 1000 lbs./FT maximum sidewall pressure.

Specifications

Select a set of products below for more information:
Conductor Ground Wire
No. of Conductors Size (AWG or kcmil) (mm2) No. of Strands Insulation Thickness (mils) (mm) Size (AWG) No. of Strands Nom. OD (mils) (mm) Nominal Total Weight (lbs/1000') (kgs/km) Allowable Ampacity
890105
1 1
1/0 AWG 1/0 AWG
19 19
80 2.03
530 13.46
396 590
890106
1 1
2/0 AWG 2/0 AWG
19 19
80 2.03
572 14.53
488 727
890631
1 1
3/0 AWG 3/0 AWG
19 19
80 2.03
624 15.85
604 899
890107
1 1
4/0 AWG 4/0 AWG
19 19
80 2.03
680 17.27
748 1114
890632
1 1
250 KCMIL 250 KCMIL
37 37
95 2.41
742 18.85
892 1328
890108
1 1
350 KCMIL 350 KCMIL
37 37
95 2.41
861 21.87
1224 1821
890109
1 1
500 KCMIL 500 KCMIL
37 37
95 2.41
966 24.54
1707 2541
890633
1 1
750 KCMIL 750 KCMIL
61 61
110 2.79
1200 30.48
2551 3797

Standards & References

  • ASTM B3: Soft or Annealed Copper Wire
  • ASTM B8: Concentric-Lay-Stranded Copper Conductors
  • UL 44: Thermoset-Insulated Wires and Cables
  • UL 854: Service Entrance Cable
  • UL 1685: Vertical-Tray Fire Propagation and Smoke Release Test (1/0 and Larger)
  • ICEA S-95-658: (NEMA WC70) Power Cables Rated 2000 Volts or Less for the Distribution of Electrical Energy
  • CT USE: Sizes 1/0 AWG and Larger
  • IEEE 1202: FT4 Flame Test (70,000) BTU/hr Vertical Tray Test (1/0 and Larger)
  • VW-1: (Vertical-Wire) Flame Test
  • PR I/II: Oil Resistant
  • -40ºC Rated:

Construction

  • Conductor: Class B compressed stranded bare copper per ASTM B3 and ASTM B8
  • Insulation: Cross Linked Polyethylene (XLPE) Type RHH/RHW-2 USE-2 Silicone-Free

Resources

There are no downloadable resources for this product.